Hitachi PSC-A32MN - Page 77

5.4.3 Exception Setting of Run/Stop Operation
“RUN” and “STOP” orders are not accepted when the group is set to operation in “All groups” or “All blocks”.
+RZHYHULWLVSRVVLEOHWRVHWDQH[FHSWLRQUXOHIRUDQ\RIWKHIROORZLQJRUGHUVRUFRPELQDWLRQVRIRUGHUVDIIHFWLQJVSHFL¿FJURXSV
 None
 Run + Stop
 Stop
 Run
 N O T E
 7KHIROORZLQJFRPPDQGVDUHDIIHFWHGZKHQWKLVIXQFWLRQLVVHW
- 6FKHGXOHG7LPHU2SHUDWLRQ
- ³$OO5XQ6WRS´DQG³5XQ6WRSE\%ORFN´E\([WHUQDO,QSXWFRPPDQG
 ³5XQ6WRS´RSHUDWLRQLVDYDLODEOHZKHQWKHJURXSLVVHOHFWHGLQGLYLGXDOO\
1 Select “Exception Setting of Run/Stop Operation” on the “Service Menu” screen.
2 Select the operation to exclude. The selected operation is highlighted in yellow.
(1)
(2)
3 Select the target for the rule of exception for the selected operation (group/block)
 Tap on a Group button to switch the selection state of that group.
 Tap on a Block button to switch the selection state of all the groups in that block.
 The selected groups are indicated with a check mark.
4 7DS³6HWWLQJFRPSOHWHG´WRFRQ¿UPWKHVHWFRQWHQWVDQGWRUHWXUQWRWKH³([FHSWLRQVHWWLQJRI5XQ6WRS2SHUDWLRQ´VFUHHQ
(3)
(4)
ENGLISH
Operation
PMML0332A rev.0 - 05/201569