Hitachi PSC-A32MN - Page 82

Other settings
10 Select the target of External Input Control. (All Groups/Block/Group).
 Tap the button of a Group to switch its selection state.
 Tap the button of a Block to switch the selection state of all the Groups in the Block.
 Tap the “All Groups selection” button to switch the selection state of all the Groups.
 The selected groups are indicated with a check mark.
11 7DS³6HWWLQJFRPSOHWHG´WRFRQ¿UPWKHVHWFRQWHQWVDQGUHWXUQWRWKH([WHUQDO,QSXW2XWSXW6HWWLQJVFUHHQ
(10) (11)
5.4.4.5 External Output Setting
1 Select “External Input/Output Setting” on the Service Menu screen.
Selection is not possible when air conditioners are in operation, or when the contact for external input signal is ON.
2 Select the Output target of the External Output (Output 1, Output 2).
(1)
(2)
3 Select the function to be used with the external output.
The button for the selected function is highlighted in yellow.
4 Tap “Service Menu” to complete the external Input/Output Setting and return to Service Menu screen.
(3)
(4)
Operation
PMML0332A rev.0 - 05/201574