10
Connect to the smartphone
If the pairing setup fails
1. Make sure that the wireless LAN password, which was entered in 4 , is correct
2. Make sure that the smartphone and its OS is targeted model
3. Make sure that the wireless LAN router’s communication standard corresponds to IEEE.802.11b/g/n (2.4 GHz only). It does not correspond 5 GHz.
4. 4 Check whether the smartphone is connected to the 5 GHz SSID or wireless LAN router.
5. Set the unit, smartphone and wireless LAN router close to each other.
6. Only one pairing can be set at one time. Set them one by one.
7. One unit can be connect to only 5 smart phone devices.
8. The following devices may be affected by radio waves, and this product may not be able to communicate with the smartphone temporarily.
・
Microwave oven during heating
・ Other wireless LAN devices
・
Bluetooth device etc.
Set wireless LAN feature to “None”
How to other Wireless LAN feature
Delete all registration information (initialization)
・
・ The registered information of the paired smartphone is not deleted.
・ When using the wireless LAN function again, it is not necessary to
●
●
●
2
Press
1,2 Second
and
all registation information.
1
Press
1,2 Second
WLAN lamp light is on.
If the wireless LAN feature is set at “No” , functions that can be
Press
1,2 Second
WLAN lamp light is off.
Set the names of the unit and user in the application
and complete the setting.
8
Move back to the application and wait for a while until pairing setting is finished. When finished, set the names of the unit and user,
and complete the pairing setup.
Operate the application
operated with a smartphone cannot be used.(>>P.11)
rep-do the pairing settings.
Enter the name within 16 characters.
Set the names of the unit
and user
the setting
on the unit changes from blinking to lighting
Half-width symbols, such as “ * ” , “ / ”
and “ ( ” , cannot be used.
Tap “Exit” to complete
2 second
2 second
2 second together for delete
To Next Page
Loading...
Need help?
General
