Operation procedure
• Remote control operation procedure
7 Timer button
Under ON status, press this button to set timer OFF; Under OFF status, press this
button to set timer ON.
Press this button once and the characters of HOUR ON (OFF) will flash to be
displayed. Meanwhile, press “+” button or “-” button to adjust timer setting (time
will change quickly if holding “+” or “-” button). Time setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters of HOUR ON
(OFF) will stop flashing.
If the characters are flashing but you haven’t pressed timer button, timer setting
status will be quitted after 5 seconds. If timer is confirmed, press this button again
to cancel timer.
8 Light button
Press the button to activate or deactivate the LED (Light) on control panel.
9 Health button (Not Applicable)
WiFi Function (Not Applicable)
WiFi function are not applicable for models of RAW-VJ07SCASK / RAW-VJ10SCASK /
RAW-VJ13SCASK / RAW-VJ18SCASK and RAW-VJ24SCASK.
Press “Mode” + “Timer” button together to disappear “WiFi” symbol onto display.
Function introduction for combination buttons
Temperature display switchover function
Under OFF status, press "-" and "Mode" buttons simultaneously to switch temperature
display between °C and °F
To Next Page
Loading...
