– 1 –
NAMES AND FUNCTIONS OF REMOTE CONTROLLER
REMOTE CONTROLLER
This controls the operation of the air conditioner. Signal range to reach air conditioner is about 7 meters.
If inverter lamp is used, the range of control may be shorter.
It can be fi xed on a wall using the fi xture provided. Before fi xing it, make sure the air conditioner can
be controlled from the remote controller.
● Transmission sign
The transmission sign blinks when a signal is sent.
● Display
This indicates the room temperatur
e setting, timer status, operation
mode and fan speed setting.
● CIRCULATION button
Press this button to set air circulation in the room or start the
operation.
● DEHUMIDIFYING button
Press this button to dehumidify the room or start the operation.
● COOLING button
Press this button to set cooling mode in the room or start the
operation.
● RESET button
● STOP button
Press this button to stop the operation.
● SLEEP TIMER button
Press this button to set the sleep timer.
● FAN SPEED button
Press this button to change the fan speed. Every time you pr
ess
this button, the intensity of cir
culation will change from
(AUTO)
to
(HI) to (MED) to (LOW).
● AUTO SWING button
Pr
ess this button to set auto swing or stop angle of the vertical air
defl ector
.
● TEMPERATURE button
Press this button to raise or lower the temperatur
e setting. (Keep
pr
essed, and the value will change more quickly.)
● ON-TIMER button Press this button to setting the turn on time.
Precautions
● Do not put the remote controller in the following places.
● In direct sunlight.
● Near a heat source.
● Handle the remote controller carefully. Do not drop it on the
fl
oor, and away from water.
● Once the air conditioner stops, it will not restart for about 3
minutes (unless you tur
n the power switch of
f and on or unplug
the power cor
d and plug it in again).
This is to protect the device and does not indicate a failure.
To Next Page
Loading...
