– 3 –
■ Circulation Function
● During circulation operation, compressor will not run and there is no cooling operation with only
fan running.
● When the setting temperature is higher than room temperature, fan will stop running.
CIRCULATION OPERATION
Press the (CIRCULATION) button so that the display indicates pointing to button.
Circulating operation starts with a beep.
Press the FAN SPEED button and select the desired FAN SPEED (the display indicates
your choice).
Press the temperature control button to set to the desired temperature.
■ As the settings are stored in memory in the remote controller, you only have to press the
(CIRCULA
TION) button next time.
3
Press the (STOP) button to stop operation.
STOP
1
2
HOW TO SET THE SLEEP TIMER
Press the (SLEEP TIMER) button, and the display changes as shown below.
SLEEP TIMER: The device will continue working for the designated number of hours
and then turn off.
Point the signal window of the remote controller toward the indoor unit, and press
the SLEEP TIMER button.
The timer information will be displayed on the remote controller. The TIMER lamp
lights with a beep from the indoor unit.
SLEEP
TIMER
Mode
SLEEP TIMER
44
4
1
Indication
1 hr 2 hrs 3 hrs 10 hrs 11 hrs 12 hrs
Cancel sleep timer
4
4
■ After sleep timer time is up and when press sleep timer button again, the timer will be set as last setting.
■ Sleep timer effective only once.
NOTE
4
Cooling
“ ”
and
dehumidifying
“ ”
Explanation of the sleep timer
The device will control the FAN SPEED and room temperature automatically so as to be quiet and good for people’s
health.
You can set the sleep timer to turn off after 1 to 12 hours. The FAN SPEED and room temperature will be controlled
as shown below.
Function Operation
The room temperature will be
controlled 2°C above the setting
temperature and the FAN SPEED
will be set to LOW setting 1 hour
after the setting of the sleep timer.
To Next Page
Loading...
