Hitachi RAC-25RPA - Page 10

ENGLISH
– 6 –
PREPARATION BEFORE OPERATION
1. Slide the cover to take it off. 2. Install two dry batteries AAA.LR03 (alkaline). The direction of the batteries should match the
marks in the case.
1. Choose a place from where the signals can reach the unit. 2. Fix the remote controller holder to a wall, a pillar or similar
location with the provided screws.
3. Place the remote controller in the remote controller holder.
Remote controller
Screws
Remote controller holder
Ƶ To install the batteries
3. Replace the cover at its original position.
Ƶ To fix the remote controller holder to the wall
NOTE
Notes on batteries ƽ When replacing the batteries, use batteries of the same
type, and replace both old batteries together.
ƽ When the system is not used for a long time, take the
batteries out.
ƽThe batteries will last for approximately 1 year. However, if
the remote controller display begins to fade and degradation of reception performance occurs within a year, replace both batteries with new size AAA.LR03 (alkaline).
ƽThe attached batteries are provided for the initial use of
the system.
The usable period of the batteries may be short depending
on the manufactured date of the air conditioner.
Notes on the remote controller
ƽNever expose the remote controller to direct sunlight. ƽDust on the signal transmitter or receiver will reduce the
sensitivity. Wipe off dust with soft cloth.
ƽSignal communication may be disabled if an electronic-
is in the room. Consult the shop if that is the case.
ƽ If the remote controller signals happen to operate another
appliance, move that appliance to somewhere else, or consult the service shop.
ƽ When the remote controller is not in use, please close the
slide cover to prevent failure.
– 7 –
PREPARATION BEFORE OPERATION
Ƶ To set calendar and clock
1. Press (RESET) button when first time setting.
"Year" blinks.
2. Press
(TIME) button to set the current year.
3. Press
(CLOCK) button. Next, "Day" and
"Month" blink.
4. Press
(TIME) button to set the current day and
month.
5. Press
(CLOCK) button. Next, "CLOCK" blinks.
6. Press
(TIME) button to set the clock to the current
time.
7. Press
(CLOCK) button.
Calendar and clock are set. To modify the calendar and clock, press
(CLOCK)
button. Then follow steps 1 to 7. Calendar and clock shall be set again after changing batteries. After changing the batteries, 1. Press
(RESET) button.
2. Direct remote control towards indoor unit and press
(INFO) button.
3. The calendar and clock from indoor unit will be transmitted. Ƶ Calendar and clock will not be transmitted from indoor
unit when the following occurs:
ƽ When there is a power failure. ƽ When breaker is OFF by user (unit is not in STANDBY
MODE).
NOTE
Note on setting the calendar and clock. ƽ If the calendar and clock are not set, the ON-timer, OFF-timer and Weekly Timer cannot be set. ƽ If the calendar and clock are not set correctly, the ON-timer, OFF-timer and Weekly Timer will not
operate correctly.
ƽ When the ON-timer, OFF-timer and Weekly Timer are set, the calendar and clock cannot be changed. If
need to change the calendar and clock, ON-timer, OFF-timer and Weekly Timer need to be cancelled.
10