Hitachi RAC-60WPA - Attaching the Air Purifying Filters

– 9 –
ENGLISH
CAUTION
CAUTION
NOTE
!
!
1
2
3
4
ATTACHING THE AIR PURIFYING FILTERS
Open the front panel
● Pull up the front panel by holding it at both sides with
both hands.
Remove the Pre-Þ lter
● Push upward to release the claws and pull out the
Pre-Þ lter.
Attaching the air purifying Þ lters
● Attach the air purifying Þ lters to the frame by gently
compress its both sides and release after insertion
into Pre-Þ lter frame.
Attach the Pre-Þ lters
● Attach the Pre-Þ lters by ensuring that the surface
written “FRONT” is facing front.
● After attaching the Pre-Þ lters, push the front panel at
three arrow portions as shown in Þ gure and close it.
Cleaning and maintenance must be carried out when Þ lter lamp lights. Before cleaning, stop operation
and switch off the power supply.
Do not bend the air purifying
Þ lter as it may cause damage to
the structure.
Please do not smell direct from
source of Þ lter.
● In case of removing the air purifying Þ lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
Þ lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Air purifying Þ lters are not washable. It is recommended to use vacuum to clean it. It can be use for 1
year time. Type number for this air purifying Þ lter is <SPX-NTW1>. Please use this number for ordering
when you want to renew it.
● Do not operate the air conditioner without Pre-Þ lter. Dust may enter the air conditioner and fault may
occur.
Claws
(4 places)