DISPLAY OPERATION MODE SETTING
For operating indoor unit independently (without outdoor unit connection), remote controller must be set according to
below procedures before send the signal to the indoor unit. New communication format between indoor and outdoor is
required to communicate with outdoor unit.
P
ROCEDURE
2. Pr
ess the
3. Press
(MODE) selector button to choose the desired operation mode.
( ON/OFF ) button.
Then , the indoor unit will starts to operate independently according the selected operation mode.
“ "
blinking
““ "
blinking
(ON/OFF) button and
(UP/DOWN) button, press ( RESET) button on 1. While pressing and holding
the same time. Release (RESET) button only and make sure that all marks on the LCD display are indicated,
then release the (ON/OFF) button and (UP/DOWN) button. Remote controller now enters "DISPLAY
OPERATION MODE" for the indoor unit to run independently.
Please ensure that when pressingse ensure tha
butt
on,
will
be blinking.
(FAN SPEED)
NOTE :
(1)During "DISPLAY OPERATION MODE",
blinks on LCD of remote controller.
(2)
When operation stops, "DISPLAY OPERATION MODE" is canceled.
- 1
15
-
To Next Page
Loading...
