HOW TO PROHIBIT THE FILTER CLEANING OPERATION
• With the remote controller, you can deactivate the filter cleaning operation.
• This setting should be made only when the air conditioner is stopped.
Press the
(AUTO SWING VERTICAL) and (OK) buttons
simultaneously for 5 seconds.
A double short beep sounds is emitted and the filter cleaning is
deactivated.
To reactivate the filter cleaning, press the
(AUTO SWING
VERTICAL) and
(OK) buttons simultaneously for 5 seconds,
a single short beep sound is emitted and the setting returns the
filter cleaning operation.
Filter cleaning operation (Default)
(at the time of purchase)
“Beep” sound
Filter cleaning operation
is prohibited
“Beep Beep” sound
1
FILTER CLEANING OPERATION (MANUAL OPERATION)
NOTE
About the noise during filter cleaning
• A whirring motor noise is generated due to driving of the cleaning unit.
• A sweeping sound is generated when the cleaning unit sweeps the dust.
Maintenance
• No daily maintenance is required. However, dust amount varies depending on the environment in
which the air conditioner is used. Check the dust amount in the Dust Box approximately once every
years and throw the dust, if any.
• Greasy dirt can also be cleaned by the combined function of filter cleaning and the micro mesh
stainless filter. If the dirt looks heavy,remove the micro mesh stainless filter, the dust catcher and
the filter cleaning wiper to wash them with water.
CAUTION
Do not put your fingers or a stick etc into the top part of the indoor unit during filter cleaning operation.
It may result in injury or malfunction.
VERTICAL SWING
HORIZONTAL SWING
■ To start Vertical Auto Swing
■ To start Horizontal Auto Swing
■ To cancel Vertical Auto Swing
■ To cancel Horizontal Auto Swing
● Press
to swing up and down.
is displayed on the LCD.
● Press (AUTO SWING (HORIZONTAL)) button. The deflectors will
(AUTO SWING (VERTICAL)) button. The deflector will start
start to swing right and left.
is displayed on the LCD.
● Press (AUTO SWING (VERTICAL)) button again. The deflector will
stop in the current position.
disappeared from the LCD.
● Press (AUTO SWING (HORIZONTAL)) button again. The deflectors
will stop in the current position.
disappeared from the LCD.
NOTE
●
■ To start Vertical Auto Swing
■ To start Horizontal Auto Swing
■ To cancel Vertical Auto Swing
■ To cancel Horizontal Auto Swing
●
●
●
●
NOTE
● During cooling and dehumidifying operation, do not keep the deflectors swinging or in the lower position
(in the case of vertical auto swing) for a long time. It may cause dew condensation on the deflectors.
AUTO SWING OPERATION
User can use the device simply as an air circulator.
1
2
Press the MODE selector so that the display indicates
(FAN).
Set the desired FAN SPEED with the (FAN SPEED) button (the
display indicates the setting).
(HIGH) (MED) (LOW) (SILENT)
Press the
(START/STOP) button. Fan operation starts with
a beep. Press the button again to stop operation.
START
STOP
To Next Page
Loading...
