EasyManua.ls Logo

Hitachi RAK-25PSEW - Basic Mode

Hitachi RAK-25PSEW
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MODEL
Set to "ultra-Lo","Silent","Lo","Med","Hi","ultra-Hi" or "stop" depending on the room
temperature, time and heat exchanger temperature. Set to "stop" if the heat exchanger
temperature is "DNZKOF" during Thermo OFF.(When reach at "DNZKON", fan speed set
to "ultra-Lo" again.)
Set to"ultra-Hi"
Set to "ultra-Lo","Silent","Lo","Med","Hi","ultra-Hi" or "stop" depending on the room
temperature, time and heat exchanger temperature. Set to "stop" if the heat exchanger
temperature is "DNZKOF" during Thermo OFF.(When reach at "DNZKON", fan speed set
to "ultra-Lo" again.)
Set to "ultra-Lo","Silent","Lo","Med","Hi","ultra-Hi" or "stop" depending on the room
temperature, time and heat exchanger temperature. Set to "stop" if the heat exchanger
temperature is "DNZKOF" during Thermo OFF.(When reach at "DNZKON", fan speed set
to "ultra-Lo" again.) The fan speed is controlled by the heat exchanger temperature; the
overload control is executed as in the following diagram:
button
button
button
button
“ultra-Lo”
Operates at “Lo” regardless of the room temperature.
Runs at “ultra-Lo” when thermo is off.
Operates at “Silent” regardless of the room temperature.
Runs at “ultra-Lo” when thermo is off.
Operates at “Med” regardless of the room temperature.
Runs at “ultra-Lo” when thermo is off.
1. Runs at “Hi” until room temperature reaches to
“setting temperature-SFTDSC” after operation is
started.
2. Runs at “ultra-Lo” when thermo is off.
button
button
button
button
button
button
button
PDCIN2
PDCOF2
"Med","Lo""Silent"×108%
"Med","Lo""Silent"
Setting temperature
Room temperature
ON
Thermo judgment
Compressor
(Compressor stopped
forcibly for 3 minutes)
Hi
Med
Lo
3
ON
OFF
SFTDSC
OFTMPC
0.66℃
FCAUT_L
FCAUT_H
Set to "ultra-Lo","Silent","Lo","Med","Hi","ultra-Hi" or "stop" depending on the room
temperature, time and heat exchanger temperature. Set to "stop" if the heat exchanger
temperature is "DNZKOF" during Thermo OFF.(When reach at "DNZKON", fan speed set
to "ultra-Lo" again.)
When the compressor is running at maximum
speed
during hot-dash or when recovered from
defrosting.
In modes other than left
Heat exchanger temperature
DASUPHH
DASUPH
DASDNH
DASDNH
NORUPS
NORUPL
NORUPH
NORDPH
NORDNL
NORDNS
Ultra-High
High
Med
Low
Silent
" 0 9" 0 9
DASUPL
DASUPS
DNZKON
DASDNL
DASDNS
DNZKOF
Fan speed UP/DOWN delay time
Fan speed UP/DOWN delay time
52
53
RAK-25/35/50PSEW, RAK-25/35/50PSES
51
54
50
49
46

Related product manuals