Hitachi RAS-10JH4 - Air Intake Filter and Air Exchange Procedures; Various Functions; Automatic Operation; Auto Restart Control

– 11 –
HSILGNE
Removing the Fresh Air In Pre-Filter • Please pull out.
Removing the Nano-Titanium Disinfecting Deodorizing/Dust Collecting Fresh Air In Filter Case • Please hold the
handle of the Nano- Titanium Dis- infecting Deodori- zing/Dust Collecting Fresh Air In Filter Case and pull out.
Attaching the Nano-Titanium Disinfecting Deodorizing/Dust Collecting Fresh Air In Filter
Attaching the Nano-Titanium Disinfecting Deodorizing/Dust Collecting Fresh Air In Filter Case
• Please hold the
handle of the case and attach along the slot, and then keep pressing until the case clicks.
• Improper filter
installation may result in abnormal noises.
Attaching the Fresh Air In Pre-Filter • Please hold the handle and install the filter by
pushing it along the inner grooves.
Closing the Front Panel • Hold the front panel with both hands and pull
forward, then down.
• Keep pressing the front panel in the direction of
the arrow (3 places) until the panel clicks.
• If the front panel is loose, the panel may come off and fall. • When opening the front panel, please do not use excessive force. If the front panel
comes off the device, this may cause it to malfunction.
• Please do not operate the device without the pre-filter. If dust enters the machine, this
may cause it to malfunction.
• When removing and installing the pre-filter, please take sufficient care not to cut your
hand with the fin of the heat exchanger.
9
7 8
1211
10
CAUTION
Groove
AIR IN PRE-FILTER, EXHAUST PRE-FILTER, NANO-TITANIUM DISINFECTING
Nano-Titanium Disinfecting Deodorizing/Dust Collecting Fresh Air In Filter (included)
RAS-10_14JH4_Ope_EN 11
Front Panel
– 12 –
VARIOUS FUNCTIONS
• If there is a power failure, operation will be automatically restarted when the power is resumed with previous
operation mode and airflow direction. (As the operation is not stopped by remote controller.)
• If you intend not to continue the operation when the power is resumed, switch off the power supply.
When you switch on the circuit breaker, the operation will be automatically restarted with previous operation mode and airflow direction. Note: 1. If you do not require Auto Restart Control, please consult your sales agent.
2. Auto Restart Control is not available when Timer or Sleep Timer mode is set.
AUTOMATIC OPERATION
Press the (START/STOP) button.
■ Direct selection
Press the (AUTO) button. Operation start with a beep at previous AUTO mode.
1
STOP
AUTO RESTART CONTROL
The device will automatically determine the mode of operation, HEAT or COOL depending on the initial room temperature. The selected mode of operation will change when the room temperature varies.
RAS-10_14JH3_Ope_EN 05/12/2008, 04:43 pm12