5''
ON
OFF
OFF
OFF
ON
3'03''
3'03''
1. The product will be considered to
have a go-route error if the limit
switch is detected within 2 minutes
23 seconds (= 2'33" - 10":10" is the
safety time) after the dust box side
is started.
2. The product will be considered to
have an error when 2 go-route errors
are finalized.
ON
OFF
OFF
OFF
ON
2'33'' 2'33''
2'33'' 2'33''
5'' 5''
Cleaning settings can be selected
by double-pressing the remote
control unit
(function selector on/off +
manual cleaning, held down for 5 seconds).
1. Reverse the current setting.
Cleaning enabled disabled
2. In the case of an error,
this can cancel the display.
Limit
switch
Initialization
side
Operation lamp
Cleaning lamp
Operation diagram for filter cleaning (error detection 2)
Arrival error (lock)
Power
Product command
Initialization
--> dust box
Dust box -->
initialization
Cleaning initiated
Lit 4 seconds /
off 1 second
1. If the limit switch is not detected 3 minutes
3 seconds (= 2'33" +30":30" is the safety time)
after startup, the product will be considered
to have an arrival error.
2. If the startup-side limit switch is detected
during reversing, the product will stop for
5 seconds and restart itself in the direction
of advance.
3. If 2 arrival errors are finalized, the product
will be considered to have an error.
Operation diagram for filter cleaning (error detection 3)
Lit 4 seconds /
off 1 second
Limit
switch
Initialization
side
Operation lamp
Cleaning lamp
Power
Product command
Initialization
--> dust box
Dust box -->
initialization
Cleaning initiated
– 83 –
Cleaning unit
driving motor
Cleaning unit
driving motor
⇔
To Next Page
Loading...
