(1) Hold the handheld parts of the front panel and lift it.
(1) Remove the screw cover from the bottom of the fancy
cover and remove the screws.
(2) Unscrew the terminal board cover and the fancy cover.
(3) Remove the terminal board cover.
(4) Remove the right upper lug of the fancy cover by inserting
a screwdriver or something similar into it.
(5) Place your hands on the right and left part of the fancy
cover, pull the bottom slightly towards you, turn it upwards,
and remove it.
(2) Move the farthest part of the right arm outwards and
remove the shaft.
(3) Move the left arm outwards, remove the left shaft, pull it
towards you, and remove it.
1) Ensure that the dew pan and cleaning unit are securely
installed.
2) After fitting the left and right parts of the fancy cover into
the body, fit the upper lugs (x 2) securely.
3) Tighten the screws in the terminal board cover and the
fancy cover securely.
4) Install the screw covers.
1) Insert the shaft of the left arm of the front panel along the
step in the body until shaft enters the hole.
2) Insert the shaft of the right arm of the front panel along
the step in the body until the shaft enters the hole.
3) After ensuring that the front panel is securely installed,
close the front panel.
Installation instructions
revoc ycnaF .2
lenap tnorF .1
Terminal board
cover
Terminal board
cover
Installation instructions
Fix the upper lugs (x 2)
Screws Screws
Screw
Screw cover
.
Screws
Fancy cover
MODEL RAS-10SH3, RAS-14SH3, RAS-18SH3
DISASSEMBLY & ASSEMBLY PROCEDURE
– 86 –
Arm
Arm
Step
Arm
Step
Arm
Push
Push
Move
Insert
Insert
lug
To Next Page
Loading...
