ā 7 7 ā
Front panel
Tool position
OFF
ON
Operating according to the settings made by remote control
Stainless steel plasma air purification operation
Electrical dust
collector
AIR PURIFICATION
button
START/STOP
button
Remote control
"AIR PURIFICATION" lit
Operation lamp
Mist and air
purification lamp
Indoor unit
Open
Closed
Vertical vane
Product operation
status
Product operation
Operating according to the settings made by remote control
Operating according to the settings made by remote control
(1) Pressing the "air purification" button on the remote control unit will activate
the stainless steel plasma air purification.
(2) If the stainless steel plasma air purification operation is set while the product
is stopped, turning on the electrical dust collector will activate the product with
wind feed.
(3) Setting the stainless steel plasma air purification operation while the product
is operating will turn on the electrical dust collector. At the same time, the
product will operate in the operation mode selected by remote control.
Notes:
To Next Page
Loading...
