Ð10Ð
Press the (START/STOP) button. Cooling operation starts
with a beep .Press the b utton again to stop operation.The cooling
function does not start if the temperature setting is higher than
the current room temperature (ev en though the (OPERATION)
lamp lights).
The cooling function will start as soon as you set the temperature
below the current room temperature.
Use the device for cooling when the outdoor temperature is -10 to 42¡C.
If humidity is very high (over 80%) indoors, some dew may form on the air outlet grille of the indoor
unit.
Press the FUNCTION selector so that the display indicates
(COOL).
Set the desired FAN SPEED with the (FAN SPEED) button
(the display indicates the setting).
(AUTO) : The FAN SPEED is HI at first and varies to MED
automatically when the preset temperature has
been reached.
(HI) : Economical as the room will become cool quickly.
(MED) : Quiet.
(LOW) : More quiet.
Set the desired room temperature with the TEMPERATURE
buttons (the display indicates the setting).
The temperature setting and the actual room temperature may
vary somewhat depending on conditions.
As the settings are stored in memory in the remote controller, you
only have to press the
(START/STOP) button next time.
Ð11Ð
Press the (START/STOP) button. Fan operation starts with a
beep.
Press the button again to stop operation.
You can use the device simply as an air circulator.Use this function to dry the interior of the indoor unit
at the end of summer.
Press the FUNCTION selector so that the display indicates
(FAN).
Press the (FAN SPEED) button.
(HI) : The strongest air blow.
(MED) : Quiet.
(LOW) : More quiet.
É When the AUTO fan speed mode is set in the cooling/heating operation:
For the heating operation
¥ The fan speed will automatically change according to the temperature of
discharged air.
¥Asroom temperature reaches the preset temperature, a very light breeze
will blow.
¥ Operation starts in the ÒHIÓ mode to reach the preset temperature.
¥Asroom temperature approaches the preset temperature, fan speed auto-
matically switches to ÒLOWÓ.
For the cooling operation
– 9 –
To Next Page
Loading...
