Hitachi RAS-18YH5 - Page 47

Intelligent power module switches power supply current according to position of the compressor motor
rotor.
The switching order is as shown in Fig. 4-2.
At point E : U
+
is ON, V
Ð
is ON (circuit in Fig.4-1)
At point F : U
+
is chopped (OFF), V
Ð
is ON (circuit in Fig.4-4)
Upper arm transistor is controlled to ON/OFF by 4.8kHz chopper signal.Rotation speed of the compressor
is proportional to duty ratio (ON time/ ON time + OFF time) of this chopper signal.
Time T in Fig. 4-2 shows the switching period, and relation with rotation speed (N) of the compressor is
shown by formula below;
N=60/2 X 1/T
Fig. 4-3 shows voltage waveform at each point shown in Figs. 4-1 and 4-4. First half of upper arm is
chopper, second half is ON, and first half of lower arm is chopper, second half is ON.
U
Ð
diode → Point A (Fig. 4-4)
When power is supplied U
+
→ V
Ð
, because of that U
+
is chopped, current flows as shown below;
(1) When U
+
transistor is ON: U
+
transistor → U coil → V coil → V
Ð
transistor → DC current
detection resistor → Point B (Fig. 4-1)
(2) When U
+
transistor is OFF: (by inductance of motor coil) U coil → V coil → V
Ð
transistor →
V
Time
W
T
V
U
V
Upper arm
transistor
Lower arm
transistor
W
U
EF
++ ++
---
Fig. 4-2 Switching order of power module
Fig. 4-3 Voltage waveform at each point
U transistor chopped
Chopping period (208µ sec.)
Chopping period
T
transistor ON
◯
B
◯
A
U
280V-300V
Voltage at
Upper arm transistor
Current at
ON
+
-
– 51 –