Hitachi RAS-(4-12)HRNM(2)(E) - Outdoor Units RAS-(4-6)H(V)RNM2 E; Remove Air Outlet Grille

10 Servicing
372
SMGB0064 rev.0 - 08/2011
10.2.2 Outdoor units RAS-(4-6)H(V)RNM2E

Removing service cover
N O T E
• Remove the main parts according to the following procedures.
- To reassemble perform the procedures in reverse.
- To prevent contamination of the refrigerant with water or foreign particles do not expose open to atmos-
phere for long periods.
- If necessary seal pipe ends using caps or tape.
1 Remove the four (4) xing screws.
2 Slide the service cover downward and remove it.
3 Pay attention of not falling off the service cover.
1. Service cover.
1

Remove air outlet grille
1 Remove the eight (8) xing screws.
2 Lift the air outlet grille holding the lower parts.
3 Release the extruded hook of the air outlet grille from the
shroud.
1. Air outlet grille.
2. Shroud.
1
2
2