7
INSTALLATION OF OPTIONAL AIR PANEL: P-N23WAM
9
Installing Air Panel
1. Fix the long screw to the fixing plate temporary.
2. Set the corner of the refrigerant connection portion of
the indoor unit to the position indicated as “PIPE SIDE”.
3. Hook the air panel onto the long screw (2 positions) so
that temporary positioning is available.
4. Mount the air panel onto the air panel fixing position by
using the factory-supplied fixing screws (M5 cross screws).
(mm)
NOTE:
Fix the (A),(B) position and after fix the other side.
5. Check to ensure that there is no gap around the
contacting surface between the indoor unit and the air
panel. Any gap may cause air leakage or dewing.
(mm)
Installing Cover for Cover Pocket
1. Attach the corner pocket covers after mounting air
panel:
Hook the band at the rear side of the cover for the
corner pockets onto the pin of the panel as shown
below.
2. Hook the L-shapped nail located at the rear side of the
cover for the corner pockets onto the square hole of the
air panel (2 portions). Fix the cover for the corner
pockets with a screw.
CAUTION:
- Not tighten long screws enough may cause
something wrong as below.
- If there is a gap, even if tighten long screws sufficient,
readjust the height of indoor unit.
To Next Page
Loading...
