Hitachi RCIM-2.0FSN - 5.1.6. TIMER OPERATION PROCEDURE; Setting Current Day and Time; Timer Programming

REMOTE CONTROLLER OPERATION
7
5.1.6. TIMER OPERATION PROCEDURE
 Setting current day and time
1. Hold down the SELECT(Ï) DAY switch for more than 3 seconds to change to current day
setting mode. SET is indicated and the day blinks. All the days except the current day are
indicated.
2. Press SELECT(Ï) DAY/SCHEDULE switch until the actual day flickers, then press OK switch.
Selected day is indicated and “time” flickers.
3. Press the SELECT(Ï) DAY switch to adjust the “hour” setting, and then press again. “Hour” is
indicated and “minutes” flickers.
4. Press SELECT(ÎÏ) DAY/SCHEDULE switch to adjust “minutes”, and when adjusted press
OK switch. The current time setting mode ends and returns to normal mode. “Minutes” is
indicated and SET is lighted off. “Seconds” starts from zero.
 Setting the timer (programming)
1. Press the TIMER switch. SET and SCHEDULE are indicated. Schedule Number “1” flickers and
other numbers are indicated.
2. When the schedule switch is pressed Î, , the schedule number moves
[1]ĺ[2]ĺ[3]ĺ[4]ĺ[S]ĺ[1]….
- Select [S] to set the ON/OFF time and temperature shifts.
- *By pressing TIMER switch, SET and SCHEDULE are lighted off and changed to normal mode.
3. When the OK switch is pressed, the selected schedule number is indicated. Other schedule
number are lighted off, and “Hour” of ON time for the selected schedule Number flickers.
4. Press the SELECT(ÎÏ) DAY/SCHEDULE to adjust the “minutes” setting, and then press
again. “Hour” is indicated and “minutes” flickers.
5. Press the SELECT(ÎÏ) DAY/SCHEDULE switch to adjust the “minutes” setting, and then
press again. “Minutes” is indicated and “hour” of OFF time flickers.
6. Set the OFF time the same way as the ON time. After setting “minutes”, OFF time is indicated.
If the schedule number [1][2][3][4] is selected, the indication changes to set the schedule
number shown in 2. If [S] is selected, see the section on setting temperature shifts for details.
7. When the (ÎÏ) DAY/SCHEDULE switch is pressed, the SET and SCHEDULE indicators go
out and the mode returns to normal.