Hitachi RCIM-2.0FSN - Applying Schedules and Timers; Applying a Schedule; Cancelling Timers and Setting Shifts

8
REMOTE CONTROLLER OPERATION
 Defining the schedule to be applied
1. Hold down the (ÎÏ) DAY/SCHEDULE switch for more than 3 seconds and the SET
indicator appears. All the days and schedule numbers are indicated.
2.Press (ÎÏ) DAY/SCHEDULE switch until the day to be set flickers.
By pressing it, the day flickers
[Mon]ĺ[Tue] ĺ… ĺ [Sun]ĺ[Mon~Sun]ĺ[Mon~Fri]ĺ[Sat, Sun] ĺ [Mon]…
In case of flickering various days, the same setting is applied to the days.
3. Press the (Î) DAY switch until the schedule number you wish to set blinks.
4. Press the (Ï) SCHEDULE switch, and the SCHEDULE indication appears. Then the
schedule number indicated in step 3 is applied to the days set in step 2. Press the OK
switch to activate or deactivate the schedule. If the schedule is activated, the word
SCHEDULE is lit up.
5. Press the TIMER switch and the SET indicator goes out, and the mode returns to normal.
 Cancelling the timer
In normal mode, press (ÎÏ) DAY/SCHEDULE switch simultaneously more than 3 seconds.
The NEXT SCHEDULE indicator blinks. (Cancellation of all the timer)
During the TIMER cancellation mode, press (ÎÏ) DAY/SCHEDULE switch simultaneously
more than 3 seconds. NEXT SCHEDULE is indicated. (Timer activation)
 Setting the temperature shifts (energy saving mode)
1. Perform the ON/OFF time setting operation of sub-chapter point 1 and 2, and then select
“S” as a schedule number
2. Set the ON/OFF operation in steps 4,5 and 6 of the “Setting the timer” section, and set the
ON/OFF time. The temperature setting is then indicated.
3. Select the temperature to shift by :; switches. “3” or “5” can be selected. In this time, if
reset switch is pressed, shift temperature is not performed indicating “- -“. When the TIMER
switch is pressed, the temperature is indicated and the mode changes to schedule number
selection.
4. When the TIMER switch is pressed, the SET and SCHEDULE indicators go out and the
mode returns to normal.
 NOTE:
1. When this operation is performed, the temperature shift indicator changes.
2. When this operation is performed, the temperature setting of the CSNET WEB or PSC-5S has a normal range, while
the remote control setting may be changed to a new range.
3. The increase or decrease in the temperature setting during the scheduled time (±3 ºC or ±5 ºC) varies according to the
operation mode.
- If the system is operating in FAN, COOL or DRY mode, the temperature variation is + .
- If the system is operating in HEAT, mode, the temperature variation is - .