Do you have a question about the Hitachi RPC-2.0FSNE and is the answer not in the manual?
Provides safety precautions and warnings for operation.
Important notices and guidelines for system operation and manual usage.
Details the system components and its operating modes.
Pre-operation checks and precautions before starting the system.
Explains the operation and functions of the remote control.
Details how to adjust the swing louver for different unit types.
Explains various automatic control functions of the air conditioner.
Provides guidance on identifying and resolving common operational issues.
Identifies and illustrates the components of the outdoor units.
Illustrates the refrigerant flow for single and twin system configurations.
Provides instructions and safety precautions for installing outdoor units.
Covers material selection, piping, and refrigerant charging procedures.
Details the drain piping setup for the outdoor unit.
Outlines electrical wiring procedures, checks, and DIP switch settings.
Provides specific installation instructions for the remote control switch.
Details procedures for performing test runs after installation.
Lists safety summaries and control device settings for units.
Lists and explains alarm codes and their potential causes.
Provides safety precautions and warnings for operation.
Important notices and guidelines for system operation and manual usage.
Details the system components and its operating modes.
Pre-operation checks and precautions before starting the system.
Explains the operation and functions of the remote control.
Details how to adjust the swing louver for different unit types.
Explains various automatic control functions of the air conditioner.
Provides guidance on identifying and resolving common operational issues.
Identifies and illustrates the components of the outdoor units.
Illustrates the refrigerant flow for single and twin system configurations.
Provides instructions and safety precautions for installing outdoor units.
Covers material selection, piping, and refrigerant charging procedures.
Details the drain piping setup for the outdoor unit.
Outlines electrical wiring procedures, checks, and DIP switch settings.
Provides specific installation instructions for the remote control switch.
Details procedures for performing test runs after installation.
Lists safety summaries and control device settings for units.
Lists and explains alarm codes and their potential causes.
| Type | Split System |
|---|---|
| Power Source | 220-240V, 50Hz |
| Energy Efficiency Ratio (EER) | 3.21 |
| Coefficient of Performance (COP) | 3.61 |
| Refrigerant | R410A |
| Outdoor Unit Noise Level | 50 dB(A) |












Loading...