Hitachi RPC-5.0FSN2E - Page 33

33
INSTALLATION AND OPERATION MANUAL
ENGLISH
¡ DSW1: For Test Run
Setting before shipment
¡ DSW2: Optional Function Setting
Setting before shipment
¡ DSW3: Capacity
3HVRNME 4HVRNM1E
Setting position
5HVRNM1E 6HVRNM1E
4HRNM1E 5HRNM1E
6HRNM1E
4HVRNS1E
5HVRNS1E 6HVRNS1E
¡ Refrigerant Cycle No. Setting
DSW4
Setting position
(Setting for the ten digit).
RSW1
Setting position.
(Setting for the last digit).
¡ DSW5: Transmission Setting of End Terminal Resistance
Setting before shipment
¡ DSW6: Function setting
(RAS-3~4H(V)RNM(1)E) (No setting is required)
Power source setting
400 V 230 V
IVX ES
(RAS-5~6H(V)RNM1E and RAS-4~6HVRNS1E) (Setting is required)
Power source setting
IVX ES
¡ JP1~6: Jumper cable
No setting is required
JP1 cut: Fixing Cooling Mode
JP5 cut: Alternative Defrosting
JP6 cut: High-Pressure Control
Based on R407C Piping
13.3. COMMON WIRING
 CAUTION:
All the eld wiring and electrical components must comply with local
codes.
PMML0197_r0_04-10.indb 33 08/07/2010 9:20:55