Do you have a question about the Hitachi RPK-4.0FSNM and is the answer not in the manual?
Cooling Capacity | 4.0 kW |
---|---|
Power Source | 220-240V, 50Hz |
Refrigerant | R410A |
Outdoor Unit Noise Level | 50 dB(A) |
Outdoor Unit Weight | 32 kg |
Type | Split |
Energy Efficiency Ratio (EER) | 3.5 |
Immediate hazard that WILL result in severe injury or death.
Hazards or unsafe practices that COULD result in minor personal injury or product damage.
Hazards or unsafe practices that COULD result in severe personal injuries or death.
Supply electrical power for approx. 12 hours before start-up after long shutdown to prevent compressor failure.
Detailed description of the PC-P1HE remote control unit and its buttons.
Steps to take before operating the system for cooling, heating, dry, and fan modes.
Procedure for adjusting temperature, fan speed, and air louver direction using the remote control.
Explains indications on the remote controller when the system is in an abnormal condition.
Compressor remains off for at least 3 minutes after stopping to prevent short cycling.
System automatically restarts after short power interruptions, retaining settings.
Common issues and their potential causes and solutions, including normal sounds.
Troubleshooting steps for poor cooling or heating performance.
What to do if troubleshooting steps do not resolve the issue; contact service contractor.
Instructions on how to hang and transport the outdoor unit safely.
Guidelines for selecting the installation location and required space around the outdoor unit.
Information on preparing and selecting copper pipes for refrigerant piping.
Specific instructions for refrigerant piping work for outdoor units, including material selection and safety precautions.
Specifies the required tightening torque for pipe sizes and bolts.
Procedure for evacuating the system and charging it with refrigerant.
Specifies tightening torques for FSN(E) and FXN(E) models.
Information on refrigerant leakage, permissible concentrations, and calculation methods.
Procedure for calculating and adding refrigerant based on piping length and indoor units.
Method for calculating the additional refrigerant charge amount.
Calculation method for additional refrigerant charge for liquid piping.
Details on wiring connections between indoor and outdoor units, including H-Link system wiring.
Guide to setting DIP switches on the outdoor unit for various functions.
Checklist of items to verify before performing the test run.
Step-by-step procedure for performing a test run using the remote control switch.
Procedure for performing a test run directly from the outdoor unit's DIP switches.
Table listing alarm codes, categories, contents of abnormality, and leading causes.