What to do if the lid of my Hitachi Washer does not open?
If the lid of your Hitachi Washer won't open, it could be because the lid lock indicator is lit, meaning the lid is locked (wait for the lock to be released). Alternatively, a power outage or turning off the power while the lid lock indicator was lit could also cause this. If this happens, turn the power back on and wait for the lock to be released.
Why is water added again during the wash cycle of my Hitachi SF-125XA Washer?
During the wash cycle, your Hitachi Washer may add water automatically up to the set water level. This happens if the water level falls because the laundry absorbs water. This is a normal function.
Why my Hitachi SF-125XA Washer does not operate?
Your Hitachi Washer might not be operating due to several reasons: the power plug may not be properly inserted into the outlet (ensure it is securely plugged in), there could be a power outage (wait for the power to be restored), or the Delay Timer might be activated (disable the Delay Timer).
Why is the wash time longer than set on my Hitachi SF-125XA?
If the wash time on your Hitachi Washer is longer than what you manually set, it could be due to low water pressure. A longer water supply time increases the operating time. Check the water pressure to resolve this.
What to do if my Hitachi Washer stops during the spin cycle and starts adding water?
If your Hitachi Washer stops during the spin cycle and starts adding water, it's likely because the laundry is extremely off balance. The washer stops the spin cycle and initiates the rinse cycle to rebalance the load. To fix this, rebalance the laundry inside the drum.
Why does the remaining time increase during operation of my Hitachi Washer?
The remaining time on your Hitachi Washer may increase during operation as the washer adjusts to compensate for the speed of the incoming water. This is a normal operation.
Why doesn't the water flow strength change on my Hitachi SF-125XA when I adjust the indicator?
The strength of the water flow on your Hitachi Washer might not change when you adjust the indicator because the water flow is automatically adjusted according to the process and the load amount. This is not abnormal.
Why is my new Hitachi SF-125XA wet inside?
If your new Hitachi Washer is wet inside (drain hose, tub, etc.), it is likely due to moisture or water left from a performance test conducted before shipping from the factory. This is normal, and no action is needed.
To Next Page
General
