EasyManua.ls Logo

Hitachi SF-125XE - User Manual

Hitachi SF-125XE
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Operating & Installation Instructions
Fully Automatic Washing Machine
Model SF-125XE / 105XE
EN
Thank you for purchasing a Hitachi fully automatic washing machine.
Please read these operating & installation instructions carefully for proper
operation of the machine.
Please keep these operating & installation instructions for future reference.
Contents
Environmentally Friendly Waste Disposal 2
Hints and Tips for Eco-friendly Washing 2
Safety Instructions 3
Parts and Accessories 5
Control Panel and Display 6
Before You Start Washing 8
How to Use the Washing Machine 9
List of Programs 14
Partial Operations Using the Fuzzy Program
18
In Case of Power Outage 21
Care and Maintenance 21
Troubleshooting 23
Error Codes 24
How to Install the Washing Machine 25
Customer Service 30
Speci cations 30

Questions and Answers

  • G
    gnielsenAug 12, 2025
    What to do if the lid of my Hitachi SF-125XE Washer does not open?
    • R
      Richard LongAug 13, 2025
      If the lid of your Hitachi Washer does not open: * Check if the lid lock indicator is lit. If it is, the lid is locked. Wait for the lid lock to be released. * If there was a power outage or the power was turned off while the lid lock indicator was lit, turn the power back on and wait for the lock to be released.
  • B
    brittany40Aug 16, 2025
    What to do if my Hitachi Washer does not operate?
    • M
      michaelhansonAug 16, 2025
      If your Hitachi Washer doesn't operate, check these potential causes: * Ensure the power plug is properly inserted into the power outlet. If it isn't, insert it. * Check for a power outage. If there is one, wait until the power is restored. * See if the Delay Timer has been activated. If so, disable the Delay Timer.
  • J
    Julie SchultzAug 20, 2025
    Why does my Hitachi SF-125XE stop during the spin cycle and start adding water?
    • D
      david55Aug 20, 2025
      If your Hitachi washing machine stops during the spin cycle and starts adding water, it's likely because the laundry is extremely off balance. The machine stops the spin cycle and starts the rinse cycle to rebalance the load. To resolve this, rebalance the laundry inside the drum.
  • K
    Katrina FowlerAug 25, 2025
    Why is the wash time longer than set on my Hitachi SF-125XE?
    • L
      lisawatsonAug 25, 2025
      If the wash time on your Hitachi Washer is longer than the time you set manually, this may be because of low water pressure, which increases the water supply time. Check the water pressure to resolve this issue.
  • S
    Sharon RobertsAug 27, 2025
    Why does the remaining time increase during operation of my Hitachi SF-125XE Washer?
    • M
      Michael YoungAug 27, 2025
      The remaining time on your Hitachi Washer is adjusted to compensate for the speed of the incoming water.
  • C
    Cindy CruzAug 31, 2025
    Why is water added again during the washing process in my Hitachi SF-125XE Washer?
    • D
      Daniel ColemanAug 31, 2025
      Water is automatically added up to the set water level if the water level falls because water is absorbed by the laundry in your Hitachi Washer.
  • J
    Juan HumphreySep 4, 2025
    Why is my new Hitachi SF-125XE Washer wet?
    • G
      Greg DouglasSep 4, 2025
      If your new Hitachi Washer is wet, this is normal. There may be moisture or water left in the tub or hoses from the performance test before shipping from the factory; no action is required.
  • P
    phyllissmithSep 7, 2025
    Why doesn't the water flow strength change on my Hitachi SF-125XE?
    • R
      Robert WilsonSep 8, 2025
      The strength of water flow may not change according to the process and the load amount in your Hitachi Washer. This is not abnormal.

Hitachi SF-125XE Specifications

General IconGeneral
BrandHitachi
ModelSF-125XE
CategoryWasher
LanguageEnglish

Related product manuals