To Next PageTo Next PageWhat to do if the lid of my Hitachi SF-90XA does not open?
If the lid of your Hitachi Washer won't open, it might be locked. If the lid lock indicator is lit, wait for it to turn off. If there was a power outage while the indicator was lit, turn the power back on and wait for the lock to release.
How to troubleshoot a Hitachi SF-90XA that does not operate?
If your Hitachi Washer isn't operating, first ensure the power plug is correctly inserted into the power outlet. Also, check for any power outages in your area. Finally, if the Delay Timer is set, cancel it to start the washer immediately.
Why is the wash time longer than set on my Hitachi SF-90XA?
If the wash time on your Hitachi Washer is longer than expected, it could be due to low water pressure. Check the water pressure to ensure it's adequate.
What to do if my Hitachi SF-90XA Washer stops during spin cycle and adds water?
If your Hitachi Washer stops during the spin cycle and starts adding water, it's likely because the laundry load is extremely off balance. Try to rebalance the laundry inside the drum.
Why is water being added again during the washing process in my Hitachi Washer?
If water is being added again during the wash cycle of your Hitachi Washer, it's a normal process. The washer automatically adds water to maintain the set water level if the laundry absorbs too much water.
Why does the remaining time increase during operation of my Hitachi Washer?
If the remaining time increases during operation of your Hitachi Washer, it's normal. The washer adjusts the remaining time to compensate for the speed of the incoming water.
Why doesn't the water flow strength change on my Hitachi SF-90XA?
The strength of the water flow in your Hitachi Washer may not change, even when adjusting the indicator. This can happen depending on the wash process and the amount of laundry. This is not an abnormal behavior.
Why is my new Hitachi SF-90XA wet inside?
If your Hitachi Washer is wet even when using it for the first time, this is normal. It's due to moisture or water remaining from the performance test conducted before shipping. Simply wipe it dry before use.
Critical safety guidelines for general operation and potential hazards.
Safety measures to follow during the washing machine's installation process.
Precautions related to the power cord and electrical connections.
Safety guidelines to protect children from hazards associated with the appliance.
Important safety instructions for using the washing machine and its features.
Safety advice for performing maintenance and cleaning the appliance.
Solutions for common operational problems like not starting or abnormal cycles.
Explains error codes related to water supply and draining issues.
Interprets error codes for spin, tub, and lid lock mechanisms.
Safety precautions, recommended placement, and required clearances for installation.
Steps for connecting the drain hose and water supply to the machine.
Connecting power, leveling the machine, and post-installation verification.
General
