3
4. Preparation and confirmation of working
environment
Check and confirm if the workplace is in proper
conditions as mentioned in the general operational
precautions item 2.
5. For safety sake, use the provided Allen key to make
absolutely sure that the hexagon socket bolt is
securely clamped. Use of the unit with the bolt in a
loosely clamped condition can result in damage to
the unit and cutter as well as accidents.
Read handling
instructions before use.
Avoid any work exceeding
the maximum capacities.
(Rebar diameter ø16 mm)
Do not this electric
power tools in wet
wether conditions.
Begin operation only after
ensuring that there are no
people within the turning range
of the material to be bent.
Never bring your hand
close to the cutter
during operation.
PICTGRAPH ILLUSTRATION AND
EXPLANATION
If the switch is turned off and then
immediately turned on again, the motor
may not start. Wait for at least one full
second before attempting to turn the motor
on again after it has been switched off.
ø10
ø12
ø16
(Returning Halfway)
1 Select RETURN with the dial.
1 Pull the trigger.
(Selecting the rebar size)
Select the rebar size and the
bending angle.
6. Confirm that the cutter is in sharp condition.
Make certain that the cutter is in a sharp condition.
Continued use of a worn out and deformed cutter with
dull edges results in damage to the unit and cutter as
well as accidents.
7. Check plug receptacle.
If a receptacle jounces or a plug comes out easily when
a power cord is plugged in, the receptacle needs to
be repaired. Consult the nearest electric service station
for repair. Continued use of the defective receptacle
can result in overheating and accidents.
To Next Page
Loading...
Need help?
General
