Need help?Do you have a question about the Hitachi VM-E635LA and is the answer not in the manual?
General| Type | Camcorder |
|---|---|
| Recording Medium | VHS-C |
| Lens Diameter | 37 mm |
| Viewfinder Type | Electronic |
| Focus Adjustment | Auto/Manual |
| Minimum Shutter Speed | 1/60 sec |
| Display Type | LCD |
| Microphone Operation Mode | Stereo |
| Battery Type | Li-ion |
| Image Sensor Size | 1/3 inch |
| Display Size | 2.5 inch |
| Connector Type | S-Video |
Details technical specifications including power, dimensions, weight, and operating conditions.
Outlines the necessary maintenance and inspection procedures for the equipment.
Details on how to connect the equipment for performing circuit adjustments.
Procedure to check the camera section after replacing key components.
Step-by-step guide for setting the MAP (Memory Access Program) for service.
Procedure for performing the initial settings specific to different models.
Procedure for adjusting the electric volume control.
Procedure for adjusting the CDS sampling pulse.
Steps for performing digital adjustments on the device.
Procedure for adjusting the automatic iris control for proper exposure.
Instructions for adjusting the matrix settings for color accuracy.
Procedure for setting the white balance for accurate color reproduction.
Procedure for adjusting the chroma (color) gain for accurate color saturation.
Guidance on using a vectorscope for specific adjustments.
Detailed procedure for adjusting the autofocus system.
Procedure for adjusting the zoom trace for smooth zoom operation.
Procedure to adjust the noise level for the autofocus system.
Procedure for adjusting the image stabilizer system.
Procedure to compensate for spot noise in the image.
Procedure to adjust the deflection yoke position for the EVF.
Procedure to adjust the vertical size of the EVF image.
Procedure to adjust the focus of the EVF.
Procedures for adjusting EVF output voltage, matrix settings, and brightness.
Procedures for adjusting EVF contrast, tint, and chroma level.
Procedure for adjusting the color LCD display.
Procedure to verify VCR functionality after replacing major components.
Procedures for adjusting system control and servo circuits.
Procedure to adjust the ODC (Over Discharge Cut) power shut off level.
Procedure to adjust the head switching point for optimal performance.
Procedure to adjust filter coefficients for signal processing.
Procedure to adjust the E-E (Electric-to-Electric) video signal level.
Procedure to adjust the white clip level for video signals.
Procedure to adjust the carrier frequency of the FM modulator.
Procedure to adjust the deviation of the FM modulator.
Procedure to adjust the record luminance signal.
Procedure to adjust the playback luminance signal.
Lists common error messages and their corresponding troubleshooting steps.
Specific error messages related to VCR adjustments and their countermeasures.
Flowchart and guidance for diagnosing and resolving autofocus issues.
Flowchart for diagnosing and resolving issues where the device does not focus.
Flowchart for diagnosing and resolving issues where recording does not function.
Flowcharts for diagnosing and resolving issues with rear and front operations.
High-level block diagram showing the main functional units of the camcorder.
Table detailing the pin functions of the digital microprocessor IC.
Table detailing the pin functions of the system control microprocessor IC.
Procedure to adjust the supply and take-up cable height.
Steps for performing adjustments after replacing the cylinder.
To Next Page
