2. To configure the storage system to send notifications in syslog format, complete the settings in the Syslog tab.
Then open a firewall port on your network for transferring syslogs.
3. To configure the storage system to send notifications as SNMP traps, complete the settings in the SNMP tab.
4. Click Apply, and then click OK.
Parent Topic
• Step 6: Perform the initial setup
Initial setup of the storage system is performed using the Windows-based management console.
Step 7: Make host connections
Before you connect Fibre Channel hosts to the storage system, the storage system and hosts must be prepared.
Host attachment tasks include configuring ports and preparing the host hardware and software for connection to the
storage system. For information and instructions, see the host attachment preparation procedures in the Open-Systems
Host Attachment Guide. You will also find the following resources helpful:
• For the latest interoperability and compatibility information about supported hosts and host attachment hardware,
see the Hitachi Vantara Interoperability Reports.
• For information about preparing your hosts for use with the storage system, see the documentation for the product.
Parent Topic
• Installing your VSP G130 storage system
https://knowledge.hitachivantara.com/Documents/Storage/VSP_G130_GF350_GF370_GF700_GF900/88-03-0x/Installation/0…
Updated: Mon, 01 Feb 2021 07:07:26 GMT
Powered by
22
To Next Page
Loading...
Need help?
General