To Next PageTo Next Page
Need help?Do you have a question about the Hitachi VSP G400 and is the answer not in the manual?
Provides an overview of the CCI software and its capabilities.
Explains how to prevent concurrent configuration changes on resources.
Explains system configurations using in-band and out-of-band methods.
Describes the process and requirements for user authentication in CCI.
Describes how to prevent concurrent configuration changes on resources.
Provides steps for starting CCI instances on UNIX systems.
Details the process for starting CCI instances on Windows systems.
Explains how to configure CCI to run as a Windows service.
Introduces provisioning operations and supported storage systems.
Explains how to create and delete resource groups.
Details operations for creating and managing virtual volumes.
Explains operations for creating and managing virtual volumes with dynamic tiering.
Guides on enabling, setting, and deleting iSCSI virtual ports.
Explains how to prioritize host I/O operations for specified hosts.
Introduces data replication features of RAID storage systems.
Explains how to perform operations using ShadowImage and TrueCopy.
Details how to perform Hitachi Thin Image operations using raidcom commands.
Describes CCI operations for global-active device.
Explains ShadowImage configuration and commands.
Details TrueCopy commands and HA configurations.
Describes the creation and management of virtual volumes for copying on write.
Provides general advice for resolving CCI software issues.
Details CCI error messages and their recommended actions.
Instructions on how to contact Hitachi Data Systems customer support.
General