Operation—Operating The Machine
TX14740,0000018 –19–21MAY07–2/2
CAUTION: To prevent personal injury from
crushing or falling objects, DO NOT operate
CAB TILT controls if anyone is in or near
cab and riser area.
2. Raise cab up to operating position by pushing and
holding RAISE/LOWER switch to RAISE.
3. Install cab riser hold-down bolts. Tighten bolts to
678 N•m (500 lb-ft).
Specification
Cab Hold-Down Bolt—Torque 678 N•m...............................................
500 lb-ft
2-2-23 081407
PN=76
To Next Page
