Operation—Operating The Machine
TX14740,0000018 –19–21MAY07–1/2
Cab Tilting Procedure
T147401B –UN–02NOV01
Cab Tilt Control Panel Location
T136198 –UN–13DEC00
Cab Tilt Control Panel Switch
T164846B –UN–31JAN03
Cab Riser Hold-Down Bolts - 6 Bolt Configuration
T211970A –UN–09SEP05
Cab Riser Hold-Down Bolts - 10 Bolt Configuration
1—Cab Tilt Control Panel 2—Cab RAISE/LOWER Switch 3—Cab Riser Hold-Down Bolts
Tilt Cab For Transport
1. Remove or secure any loose objects inside the cab
that can fall when cab is tilted.
2. Turn key switch off.
3. Close cab door.
CAUTION: To prevent personal injury from
falling or from falling objects, DO NOT
operate CAB TILT controls if cab or riser is
occupied.
4. Remove the cab riser hold-down bolts (3) shown.
5. CAB TILT control panel (1) is located in the left side
rear battery compartment.
6. Tilt cab and riser to transport position by pushing
and holding RAISE/LOWER switch (2) to LOWER.
When tether cable is taut, release switch.
Raise Cab To Operating Position
1. Ensure all shipping tie-downs have been removed.
2-2-22 081407
PN=75
Continued on next page
To Next Page
