SAFETY
SA-24
BEWARE OF EXHAUST FUMES
• Prevent asphyxiation. Engine exhaust fumes can
cause sickness or death.
• If you must operate in a building, be sure there is
adequate ventilation. Either use an exhaust pipe
extension to remove the exhaust fumes or open
doors and windows to bring enough outside air
into the area.
509-E01A-0016
SA-016
PRECAUTIONS FOR WELDING AND
GRINDING
• Welding may generate gas and/or small fires.
• Be sure to perform welding in a well ventilated
and prepared area. Store flammable objects in a
safe place before starting welding.
• Only qualified personnel should perform welding.
Never allow an unqualified person to perform
welding.
• Grinding on the machine may create fire hazards.
Store flammable objects in a safe place before
starting grinding.
• After finishing welding and grinding, recheck that
there are no abnormalities such as the area sur-
rounding the welded area still smoldering.
523-E01A-0818
SA-818
AVOID HEATING NEAR PRESSURIZED
FLUID LINES
• Flammable spray can be generated by heating near
pressurized fluid lines, resulting in severe burns to
yourself and bystanders.
• Do not heat by welding, soldering, or using a
torch near pressurized fluid lines or other
flammable materials.
• Pressurized lines can be accidentally cut when
heat goes beyond the immediate flame area.
Install temporary fire-resistant guards to protect
hoses or other materials before engaging in
welding, soldering, etc..
AVOID APPLYING HEAT TO LINES
CONTAINING FLAMMABLE FLUIDS
• Do not weld or flame cut pipes or tubes that
contain flammable fluids.
• Clean them thoroughly with nonflammable
solvent before welding or flame cutting them.
510-E01B-0030
SA-030
To Next Page
Loading...
Need help?
General
