HJC RPHA 71 User Manual

3 4
1. Press the visor(shield) locker, then lift the visor(shield) tab up.
2. Open visor(shield) to the maximum open position.
3. Pull the handle-locker to the open position, then pull out the visor(shield) from ratchet mechanism.
Cheek Pad Removal
1. Ensure that the handle-locker is in the open position.
2. Align and insert the top of the shield guide into the plate-gear guide.
3. With the guides properly aligned, press the lower section of the shield into the plate-gear mechanism.
The locking tab should pop into position, locking the shield into place.
Visor(Shield) Installation
Always check to make sure helmet pads are installed before using the helmet. A helmet with
missing or improperly installed pads may increase your risk of serious injury or death in an accident.
There are 3 snaps holding the cheek pad in place.
1. Gently pry the cheek pad away from the interior, releasing the snaps.
2. Grasp the cheek pad near its center and gently pull it free from the chin strap.
Visor(Shield) Removal
1 2
Visor(shield) locker
Visor(shield) locker
Visor(shield) locker
Handle-locker
Handle-locker
Handle-locker
Handle-locker
Handle-locker
Handle-locker
Handle-locker
OPEN
OPEN
OPEN
1
2
1 2
3
OPEN
OPEN
OPEN
3
Visor(shield) tab
Visor(shield) tab
Visor(shield) tab
Warning!

HJC RPHA 71 Specifications

General

Helmet Type	Full-face
Safety Certification	ECE 22.06
Ventilation System	Advanced Channeling Ventilation System (ACS)
Retention System	Double D-ring
Shell Size	3 shell sizes
Chin Vent	Adjustable chin vent
Top Vent	Adjustable top vent
Cheek Pads	Emergency release cheek pads
Interior	Antibacterial fabric, removable and washable
Visor	Pinlock-ready
Weight	Approx. 1600g
Sizes	XS-XXL
Additional Features	Emergency quick-release cheek pads, speaker pockets
Visor Mechanism	RapidFire shield replacement system