HJC RPHA 71 User Manual

5 6
1. Align and fully slide the cheek pad plastic plate between shell and EPS.
2. Clip the cheek pad’s 3 small male snaps to the 3 female snaps xed on the shell interior.
1. Install the front section rst by aligning the plastic shell base and the crown pad plastic sleeve, ensuring
that the center and side holes are properly aligned. Press the crown pad plastic sleeve (center portion)
into the center of the channel which is built into the plasticshell base, working your way outward to each
side.
2. Align and snap the two rear snaps into place.
※Slide tab 'A' from the cheek pad into the holder 'B'.(Repeat same on opposite side)
Cheek Pad Installation
Crown Pad Removal
Crown Pad Installation
Chin Strap Cover Removal
Chin Strap Cover Installation
1. Grasp the end of the chin strap cover and pull/pry
away from the helmet.
1. Insert the chin strap into the chin strap cover and push the chin strap all the way in.
B
B
A
B
B
AA
A
1a
1b
Position of tap holder
Position of tap holder
Position of tap holder
1. Grasp the crown pad fabric as close as possible to its plastic base and pull/pry away from the helmet.
Notice how the crown pad plastic section aligns with the shell plastic sleeve. This will help orient you
with the reinstallation.
2. Repeat same at rear.
1
2
1 2
1
2
1
1a
1b
AA
A

HJC RPHA 71 Specifications

General

Helmet Type	Full-face
Safety Certification	ECE 22.06
Ventilation System	Advanced Channeling Ventilation System (ACS)
Retention System	Double D-ring
Shell Size	3 shell sizes
Chin Vent	Adjustable chin vent
Top Vent	Adjustable top vent
Cheek Pads	Emergency release cheek pads
Interior	Antibacterial fabric, removable and washable
Visor	Pinlock-ready
Weight	Approx. 1600g
Sizes	XS-XXL
Additional Features	Emergency quick-release cheek pads, speaker pockets
Visor Mechanism	RapidFire shield replacement system