It is forbidden to connect AC power to the product’s output port
(U, V, W) or other control ports except for Lk, Lb, Lz. Otherwise,
it may cause damage to the VFD.
Since internal IC can be destroyed by electrostatic, please do not
touch any PCB, IC, or IGBT components without any protection.
Otherwise, it will cause an unknown fault.
Make sure that any unexpected conductor such as screws, gasket,
etc., is not left inside the VFD during maintenance. Otherwise, it
may cause damage to the VFD or even fire.
If over current happens during starting up, please check the
wiring and start up again.
Do not stop the VFD by cutting off power. Power can be cut off
after the motor stops.
Do not leave the VFD in the sunshine. Otherwise, it may cause
damage to the VFD
To Next Page
Loading...
Need help?
General
