32
Proceed with the software upgrade according to the following steps:
• Keep the device connected to mains during the upgrading.
• Turn o the device.
• Connect the memory stick to the USB connector on the left side of the device.
• Turn on the device, and follow the instructions on the screen.
• Do not disconnect the memory stick, until instructed to do so.
• The device will restart and update the device’s main board and Treatment Head if necessary. If the
Treatment Head is not connected at the time, it will be updated the next time it is connected.
• Upgrading is complete and the device is ready for use.
If you have several PhysioTouch® - LymphaTouch® treatment devices in use, it is recommended that all
units are upgraded to the same software level.
To Next Page
Loading...