What to do if the high temperature light is on and there's no weld output on my Hobart Welding Products Welding System?
If the high temperature light is on and there's no weld output, it's possible the unit overheated, triggering a thermal shutdown. Allow the Hobart Welding Products Welding System to cool down with the fan on. You can also try reducing the duty cycle or amperage. Check for and correct any blocked or poor airflow to the unit.
What to do if there is no weld output but the power indicator light is on for Hobart Welding Products Welding System?
If there's no weld output but the power indicator light is on, ensure that weld cables are securely connected into their receptacles. Also, check the work clamp connection to the workpiece to ensure it's properly connected.
Why is the welding arc erratic or improper on my Hobart Welding Products Welding System?
If you're experiencing an erratic or improper welding arc or output with your Hobart Welding Products Welding System, consider the following: ensure you are using the correct size and type of weld cable. Clean and tighten all weld connections. You might also need to adjust your amperage setting, use dry and properly stored electrodes, or adjust the arc length. Check and if necessary, reverse the polarity, and also check and correct poor connections to the workpiece.
How to troubleshoot no weld output and no power light on Hobart Welding Products Welding System?
If your Hobart Welding Products Welding System has no weld output, the unit is completely inoperative, and the power indicator light is off, make sure the power switch is in the On position. Check that the power cord is properly plugged in and the receptacle is receiving power. Also, ensure the line disconnect switch is in the On position. Finally, inspect and replace the line fuses if needed, or reset the circuit breaker.
What to do if the fan is not operating on my Hobart Welding Products Welding System?
If the fan on your Hobart Welding Products Welding System isn't working, first check for any obstructions that might be blocking its movement and remove them. If the fan still doesn't operate, have a Factory Authorized Service Agent inspect the fan motor and control circuitry.
General| Brand | Hobart Welding Products |
|---|---|
| Model | Stickmate 160i |
| Category | Welding System |
| Language | English |
Details hazards associated with arc welding processes.
Explains how to connect the welding cables to the output terminals.
Describes how to connect the Multi-Voltage Plug Adapter for different power inputs.
Provides essential electrical service requirements and recommendations for installation.
Details the procedure for connecting the unit to a 120-volt power supply.
Details the procedure for connecting the unit to a 240-volt power supply.
Identifies and explains the function of the unit's controls and indicators.
Provides solutions for common operational issues and their possible causes.
Step-by-step guide for performing stick welding.
Guide for selecting appropriate electrodes and amperage settings.
Explains two techniques for starting a welding arc.
Addresses common welding defects like porosity and spatter with causes and remedies.
To Next Page
