07-4
Wall Lamps and Ceiling Lamp
• Briey press the key to switch each lamp on
and off. Press longer on the key to regulate
how brightly you want the lights to shine. The
brightness you set will be saved; when the
lights are switched on again, the brightness
you originally set will also be switched on
again. If the system's power supply is inter-
rupted, the wall light will shine full strength the
rst time you switch it on.
1
5
Ambience
• Press briey on the key to switch the electric
circuit of each ambience (indirect lighting) on
and off.
42 3
If the ignition of the base vehicle has
been switched on, the refrigerator
will operate automatically on 12 V,
i.e. it is not necessary to press the
main switch. All other 12 V electrical
devices will only operate on the bat-
tery of the base vehicle if the main
switch has been activated.
remain activated. The devices that were pre-
viously switched on are stored in the system;
pressing on the main switch reactivates them.
This also resets the degree to which those
lights were dimmed that can be regulated.
• Pressing the main switch for at least four
seconds while the system is switched on
will turn off not only the presently activated
devices, but also the entire 12 V system (in
self-sufcient campers, this will not cut off the
charging of the battery).
• If there should be a power failure, the system
will remember whether the main switch was
on or off. As soon as the power is back on,
the main switch will automatically switch itself
back on. Electrical devices that continuous-
ly use current, such as the heating, will then
begin to operate again.
To Next Page
Loading...
Need help?
General
