WWW.HOBBYEAGLE.COM 2 / 16
Thank you for purchasing our products. A3 Super 4 is a high-performance and functional 6-axis gyro and
stabilizer designed for R/C airplanes. For you to make the best use of the gyro and to fly safely, please
read this instruction manual carefully and set up the device as described below.
IMPORTANT NOTES
Radio controlled (R/C) models are not toys! The propellers rotate at high speed and pose
potential risk. They may cause severe injury due to improper usage. It is necessary to observe
common safety rules for R/C models and the local law. Read the following instructions thoroughly
before the first use of your gyros and setup the gyro carefully according to this manual. We also
recommend that you seek the assistance of an experienced pilot before attempting to fly with our
gyros for the first time!
After power on, the gyro needs to perform an accurate gyroscope calibration, keep the
airplane stationary after power on and wait while the LED flashes blue. The LED will stay solid
blue if a slight movement is detected and the calibration will not start until you stop moving the
airplane, however, making the airplane level is NOT required during the initialization.
A stick centering is also required following the gyroscope calibration. Always put all the sticks
center (the throttle stick in the lowest position) before power on the airplane, and do not move
the sticks until the initialization is done. The stick centering only applies to Aileron, Elevator, Rudder,
Aileron 2 and Elevator 2 channels.
Make sure to check the gyro direction of Aileron, Elevator and Rudder after installation and
always perform a test of them before each flight. An opposite reaction of the gyro could lead
to losing control or even crash!
It is recommended to use the supplied 3300uF/16V capacitor to get a more stable and secure
working voltage after installing the gyro. The capacitor can be plugged onto any one of the
free connectors of the gyro or the receiver.
To Next Page
Loading...
Need help?
General
