it is used to control dual rate of aileron, elevator and
rudder.
In AERO mode, it controls channel .
In HELI mode, it controls channel7.
See section-7
See section- .10
There are three items "S1", "S2", "S3" and "S4".
S1. Model choice
Support seven models, see Section-10
S3. Stick type choice
S4. Low voltage gate Set the voltage gate of low battery warning
In HELI mode, it is used to switch NORMAL mode
and IDLE mode. In AERO mode, it controls
channel6.
Tighten the screw when finishing adusting.
and
2 Transmitter Panel
3 Batteries C arging
4. Stic d usting
System Setting
7
To Next Page
Loading...