HobbyKing HK-7X - Flight Modes and Channel Mapping; AUX Channel Configuration; AERO Mode Details; AERO Channels Mapping

When in HELI mode, the GEAR switch controls channel 7, and the AUX channel. There are two
items in AUX channel setting, A1 and A2, control the signal of AUX channel when GEAR switch
in different position.
To enter this setting, turn on transmitter, then press UP and DN at the same time ten times, you
will see "A1 xxx like CHART 4.
CHART14 - AUX channel
Press UP or DN will change setting from A1 to A2.
Press INC or DEC will increase or decrease the value of the position.
15
1
means
the first model
VP is V-tail mode. In this mode, the LED will display like CHART1 :
means
the first model
CHART16 - V-tail mode
The channels and switches are the AERO modeseeTABLE
There are six settings in V-tail mode. To enter setting, press UP and DN at the same time for
special times, and five operations beyond is same as in HELI mode. See TABLE for details.
You can press INC and DEC at the same time to exit setting and return to using mode.
TABLE - V-tail settings
U means
V tail mode
V-tail mixture
See section- .
There are six settings in V-tail mode. To enter setting, press UP and DN at the same time special
times, and five operations beyond are the same as in HELI mode. See TABLE for details. You
can press INC and DEC at the same time to exit setting and return to using mode.
.1 u c annel setting
7. ero Mode
-tail Mode
14 1