P a r t s L i s t :
• Main wing (pair):1
• Fuselage: 1
• Stiffened of Fuselage (pair): 2
• Tail plane :1
• Rudder : 1
• Plywood Motor Mount ( set): 1
• Z-shaped steel wire : 8
• Airplane wheel and plastic wheel chock : 2
• Landing gear steel wire : 1
• Wood support plate of landing gear 1
• Servo horn : 4
• Heat shrink tube : 1
• 990 mm Carbon rod: 2
• 780mm Carbon rod: 3
• 330mm elevator 330 mm wood strip: 2
• hinge : 4
Construction:
1. Stick the 2 pieces of main wings symmetrical with 502 glue.
2. Put 2 pieces of carbon rods with 990mm length and 2mm diameter into the slot of
aircraft wing's top and bottom surface.
3. Stick the two carbon rods in the top and bottom to the aircraft wing with 502 glue to
enforce the aircraft wing's strength.
To Next Page
Loading...
