HobbyZone Super Cub S - Installing the Flight Battery

EN
7
BNF • RTF
Super Cub S
Installing the Flight Battery
CAUTION: Always disconnect the Li-Po fl ight
battery from the aircraft receiver when not
fl ying to avoid over-discharging the battery.
Batteries discharged to a voltage lower than the
lowest approved voltage may become damaged,
resulting in loss of performance and potential
fi re when batteries are charged.
Lower the throttle and
throttle trim, then power on
the transmitter for at least
5 seconds.
The Rudder and Elevator
will move, then return to
center when the aircraft is
ready to fl y.
Keep immobile and
out of the wind for
5 seconds
The aircraft can be held immobile for 5
seconds at any angle convenient for you to
connect the battery.