HOFFEN KF-65B - Changing Measurement Unit Settings; Managing Sound and Voice Alerts

HOFFEN EN
Hoffen 40
In order to clear all measurements for the current user (previously set), select
and press the button in the additional settings menu. The confirmation of erasing
the measurement memory will be the change of the flashing value corresponding to
the number of stored results (in this case the number 3) to the flashing number 0
(zero), as shown in the following figure.
CHANGE OF UNITS OF MEASUREMENT
To change measurement units from mmHg to kPa or vice versa, select mmHg or
kPa (depending on which unit was previously selected) and change the selection with
the button in the additional settings menu. The selection is confirmed by pressing
the button again or turning off the unit by pressing the "ON/OFF" button. The
change is shown in the illustration below.
TURNING THE SOUND ON AND OFF