1A-18
Chapter 1A
DASHBOARD
Lamp switch controls
The lamp switch controls the following:
• Headlamps.
• Tail lamps.
• Parking lamps.
• Number plate lamps.
• Instrument panel lamps.
Rotate the band to
to switch on your
parking and other operating lamps. The
headlamps will not come on.
Rotate the band to 9 P to switch on your headlamps. The parking and other operating
lamps will also come on.
If opening the driver’s door with the ignition in the LOCK position and the light switch
in the 8 or the 9 P position, a warning chime will sound, if the light switch is turned
off then on again while the chime is sounding the chime will be cancelled.
High/low beam
Switching between high and low beam
requires the low beam lamps to be on.
Push the lever toward the front of the
vehicle to switch from low beam to high
beam and return the lever to the original
position for low beam.
The headlamp high beam indicator lamp
on the instrument panel lights up when
the headlamps are in high beam.
Flashing high beam
It is also possible to ash the high beams
for signalling purposes by pulling the lever
toward you (even with the headlamps
switched off). The lights remain in high
beam as long as the lever is held in this
position.
Battery saver
Battery saver is to prevent the battery
from being discharged.
When you leave the lamp switch in the 8
position, they will switch off automatically
10 minutes after the ignition switch is
turned to the LOCK position.
Note If the lights are switched on 10
minutes after this feature operated the
battery saver will not function.
HEADLAMPS
CAPTIVA BOOK.indb 18 30/05/2007 12:48:51 PM
To Next Page
Loading...
