HOLDEN CG CAPTIVA 7 User Manual

176 Driving and operating
Front warning tones:
Alarm Sensing distance from bumper Alarm tone
1st alarm approx. 80-100 cm ---beep--beep--
2nd alarm approx. within 40-80 cm ---beep-beep-beep-beep-
3rd alarm approx. within 30-40 cm Alarm stays on
Rear warning tones:
Alarm Sensing distance from bumper Alarm tone
1st alarm approx. 80-120 cm ---beep--beep--
2nd alarm approx. within 40-80 cm ---beep-beep-beep-beep-
3rd alarm approx. within 30-40 cm Alarm stays on
• When the rear bumper is
approximately 30-40 cm from
the object the alarm tone sounds
continuously. See the following
table.
Notes on operation
• A short single conrmation alarm
will sound to conrm that the
sensors are operational.
• If the sensors receive other
ultrasonic signals e.g. metallic
sounds or exhaust brake noise
from heavy commercial vehicles,
the system may not work
properly.
• The system may not activate
if the sensors are frozen or
covered with dirt.
• r may illuminate on the
instrument cluster when the
sensors are dirty.
Clean dirty sensors with a soft
sponge and clean water.
If the warning light remains on,
contact a Holden Dealer as soon
as possible.
• Do not push or scratch the
surface of the sensors.
• Do not hit or direct high pressure
water directly at the sensors as
they may be damaged.
• The system may not operate
correctly when the vehicle is
driven over uneven surfaces.
• The system may not recognise
sharp objects, thick winter
clothes or other materials which
absorb ultrasonic waves.
• The alarm sounds may be
different depending on the object.
• Deactivation when towing:
RPA – The system will
automatically be deactivated
when a trailer lighting plug is
connected to the vehicle.
It will activate again when the
plug is removed.
r will illuminate on the
instrument cluster while the
trailer lighting plug is connected.
BOOK_MY14_CAPTIVA 7.indb 176 19/11/2013 2:57:10 PM

HOLDEN CG CAPTIVA 7 Specifications

General

Brand	HOLDEN
Model	CG CAPTIVA 7
Category	Automobile
Language	English