Need help?Do you have a question about the Holip HLP-A Series and is the answer not in the manual?
General| Series | HLP-A |
|---|---|
| Category | Inverter |
| Input Frequency | 50/60Hz |
| Control Mode | V/F control, Sensorless vector control |
| Cooling Method | Forced air cooling |
| Enclosure Rating | IP20 |
| Input Voltage | 3-phase 380V |
| Output Voltage | 0 to rated input voltage |
| Output Frequency | 0~600Hz |
| Power Range | 0.75~630kW |
| Overload Capacity | 150% rated current 60s; 180% rated current 10s |
| Braking Unit | Built-in braking unit |
| Communication | RS485, Modbus |
| Protection Features | Overcurrent, overvoltage, undervoltage, overload, overheating, short circuit |
| Operating Temperature | -10°C to +40°C |
| Storage Temperature | -20°C to +60°C |
| Ambient Humidity | Less than 95% RH (non-condensing) |
| Altitude | ≤1000m (Derating if exceeding 1000m) |
Crucial safety checks and precautions to take before applying power to the inverter.
Safety measures to follow while powering up the inverter.
Safety guidelines for operating the inverter correctly and safely.
Visual guide for connecting the main power and motor circuits.
Essential safety and best practice guidelines for wiring the inverter.
Overview and identification of the digital operator panel components.
Essential checks to perform before starting the commissioning process.
Procedures and steps for commissioning the inverter.
Information on fault codes displayed and methods for troubleshooting.
To Next Page
