EasyManua.ls Logo

Holmatro PA 38 H2 - User Manual

Default Icon
216 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Zalmweg 30 - P.O. Box 33
4940 AA Raamsdonkveer, The Netherlands
Tel.: +31 (0)162 - 589200
Fax: +31 (0)162 - 522482
e-mail: info@holmatro.com
home page: www.holmatro.com
/i
PA
Handleiding NL
Manual EN
Mode d’emploi FR
Betriebsanleitung DE
Manual ES
Manual PT
Manuale IT
Vägledning SV
Käsikirja FI
Vejledning DA
Instrucja obsługi PL
Veiledning NO

Table of Contents

Questions and Answers

  • T
    Tina FrenchAug 5, 2025
    What to do if Holmatro Water Pump tool is not operating?
    • L
      Lori NelsonAug 6, 2025
      If your Holmatro Water Pump tool isn't operating correctly, consider these potential causes and solutions: * Ensure all couplers are properly connected by disconnecting and reconnecting them. * Verify the pressure relief valve on the pump is in the closed (1) position. * Place the pump horizontally to ensure it is level. * Check the oil level and replenish if necessary, after setting all tools in the output position. * Vent the oil tank if the oil is foaming. * Avoid exceeding the maximum load for the tool. * If the plunger is seized, have it repaired by a Holmatro Certified Technician.
  • A
    Aaron GregoryAug 9, 2025
    Why do Holmatro Water Pump couplers not connect or disconnect?
    • R
      ramostinaAug 10, 2025
      If the couplers on your Holmatro Water Pump are not connecting or disconnecting, here are a few things to check: * Clean the couplers if they are dirty. * Release any pressure in the tool or hose using the pressure relief tool. This pressure can build up from temperature changes during storage or transport. * Ensure the couplers are aligned properly when connecting; press them together smoothly. * Support and guide the male coupler during disconnection. * Check and clean the snap ring on the female coupler for any blockage. * If the female coupler is faulty, have it replaced by a Holmatro Certified Technician.
  • D
    Donald GreenAug 14, 2025
    What to do if Holmatro Water Pump leaks oil?
    • M
      martinezdavidAug 14, 2025
      If your Holmatro Water Pump is leaking oil, check the following: * Ensure that the oil level is not too high. If it is, bring the oil level back to the correct level after setting all tools in the starting position. * Make sure the couplers are correctly connected and tighten any loose couplers.
  • E
    Emma HernandezAug 18, 2025
    Why Holmatro PA 38 H2 Water Pump couplers do not stay connected?
    • R
      Rodney GreenAug 18, 2025
      If the couplers on your Holmatro Water Pump aren't staying connected, try the following: * Hold the hose at the bending restriction while connecting if the external ring jams. * Clean the female coupler with clean running water if the locking mechanism isn't working. * Dry the coupler and treat the inside of the external ring with preservative oil. * Repeatedly place and remove the dust cap until the external ring springs back. * If the female coupler is faulty, have it replaced by a Holmatro Certified Technician.
  • A
    Austin JamesAug 22, 2025
    What to do if Holmatro PA 38 H2 plunger does not retract?
    • M
      maynarddawnAug 22, 2025
      If the plunger of your Holmatro Water Pump's hydraulic tool does not retract, or retracts slower than normal, consider these solutions: * Depressurize the system by setting the pressure relief valve to the open (0) position. * Vent the hydraulic system to remove any air. * If the cylinder return spring is broken or there's other damage to the cylinder, contact your Holmatro dealer.
  • T
    Thomas WhiteAug 27, 2025
    Why does Holmatro Water Pump flow drop and lever move back?
    • I
      ileonardAug 27, 2025
      If the flow of your Holmatro Water Pump drops and the lever tends to move back to the tank, it may be due to high vacuum in the tank. Open and close the filler cap to aerate the tank.
  • A
    Ana GarciaAug 31, 2025
    Why does Holmatro PA 38 H2 rod move upwards when there is pressure?
    • P
      Patricia WrightAug 31, 2025
      If the pump rod on your Holmatro Water Pump moves upwards when there is pressure, the check valve may be faulty. Have it repaired by a Holmatro Certified Technician.

Summary

Safety regulations

Personal safety

Lists essential personal protective equipment required during operation.

Safety regulations with respect to the equipment

Safety regulations with respect to the operation of the system

Outlines safety measures for system operation and work area.

Safety regulations with respect to maintenance

Preparation for first use

General

Operation

System operation

Overview of how the hydraulic system operates.

Pressure relief valve

Explains the function and operation of the pressure relief valve.

Connect the hydraulic hoses

General instructions for connecting hydraulic hoses.

Connect the High-Flow couplers

Step-by-step guide for connecting High-Flow couplers.

Connect the Quick-Lock couplers

Step-by-step guide for connecting Quick-Lock couplers.

Disconnect the hydraulic hoses

General instructions for disconnecting hydraulic hoses.

Disconnect the High-Flow couplers

Instructions for disconnecting High-Flow couplers.

Disconnect the Quick-Lock couplers

Instructions for disconnecting Quick-Lock couplers.

Relief the pressure in unconnected hoses or tools

High-Flow system

Quick-Lock system

Use

Before use

Steps to take before operating the pump.

During use

Instructions for operating the pump during use.

After use

Steps to follow after completing the operation.

Shut down and disconnect

Procedures for shutting down and disconnecting the equipment.

Inspection

Cleaning and storage

Troubleshooting

Troubleshooting table

Lists common problems, their causes, and solutions.

Maintenance

General

Dangerous substances

Maintenance schedule

Maintenance activities

General

General checks for pump operation, damage, and leaks.

Hydraulic coupler

Hydraulic oil

Holmatro PA 38 H2 Specifications

General IconGeneral
BrandHolmatro
ModelPA 38 H2
CategoryWater Pump
LanguageEnglish

Related product manuals